投影スクリーン displayit 5 FootのPDF 組み立て説明書をオンラインで閲覧またはダウンロードできます。displayit 5 Foot 2 ページ。 Elements display

1. Straighten and assemble all

bungeed poles.

4. Lay frames down. Pull pillowcased

graphic over frame and zip closed.

6a. If your foot is not preassembled,

slide the included screw through the

bottom and twist the nub until ﬁrmly

in place. Or, optionally screw the nub

in with a screw driver (not included).

General Assembly Instructions

2. Connect poles to corners.

(See diagram to on next page)

5a. Clamp optional lights clamp on top bar.

Tip: Put lights on before standing the display up.

6b. If your kit includes a single foot,

attach it to bottom of frame.

Secure foot with locking pin.

Elements Display

Note: Assembly is the same for all shapes and sizes of Elements Frames

3. If your kit includes a center

support pole, insert it into the

corresponding holes, located in the

top and bottom poles of the frame.

Frames over 100" wide recquire support poles

6c. If your kit includes a double foot,

connect as seen above. Frame on

right (shown in green above) attaches

to the front foot nub and overlaps the

back frame by approximately 1.5".

5b. Slide light onto clamp and

connect power cable.

6d. Nubs can be disassembled and

arranged in many variations. A total of

four frames can be attached to a single

foot. Experimentation is encouraged!

Updated 12/23/2015