- ページ 7

3Dプリンター 3D Systems ProJet MJP 5600のPDF オリジナル取扱説明書をオンラインで閲覧またはダウンロードできます。3D Systems ProJet MJP 5600 18 ページ。

ページを印刷する

When moving, DO NOT push from the front of the printer. It can tip over if casters are on uneven

ﬂooring. Always push printer from the side.

Power Requirements

Voltage

100 VAC

115 VAC

240 VAC

NOTE: All 240VAC markets require a step down transformer with 100-120VAC output for proper

heater control.

Please have 3D Systems direct or partner order the correct nationalization kit.

The installation of the printer shall comply with the National Standards and/or Electrical Codes of the

country in which it is placed.

Printer Power Considerations

During normal operation, the power usage of the printer will not exceed the continuous current rating

indicated in the electrical section (above). A dedicated, surge-and-spike protected electrical power

circuit for each printer should be provided that meets or exceeds the corresponding continuous current

rating.

Protected Power/Uninterrupted Power

A dedicated, surge and spike protected electrical power circuit is recommended for each printer installed. No other equipment is to be installed on

this circuit.

Uninterrupted power/active battery backup is recommended, especially in areas where circuits may be aﬀected by an outside source, e.g., lightning

strikes, power interruption, etc.

A 5kVA UPS supplying 120V to the product is required. The machine shall be powered by 100-120V nominal when a UPS is utilized. Some examples of

suppliers are Toshiba, APC, Eaton and Liebert. For International 230V markets, a stepdown transformer is always required. Power loss during a build

will cause the build to fail and can cause damage to your printer.

For installations with a UPS, consult the installation guide for the UPS to determine wiring and circuit requirements in advance of printer installation.

ProJet® XL Finisher (Optional) Power Requirements

The ProJet® XL Finisher must be hardwired and installed by a Certiﬁed Electrician. For more

information about the ProJet® XL Finisher click here.

Client Workstation Requirements

Before a part can be built on the printer, the build data ﬁle must be saved or exported to the industry-

standard .stl ﬁle format, and submitted over the network. The client software which is installed on the

users' workstation allows the user to select, preview, and submit jobs, as well as manage the build

queue (for designated administrators).

Prior to installing the software, ensure that each workstation meets the following minimum

speciﬁcations. The speciﬁcations described represent 3D Systems tested minimum "baseline"

conﬁguration for using the client software.

Minimum

Windows 7, 8 or 10 (64 bit)

Frequency

50/60 Hz

Phase

Single

Recommended

Amps