- ページ 4

アンテナ Aerialix ARLX-OM2400-5のPDF 建築マニュアルをオンラインで閲覧またはダウンロードできます。Aerialix ARLX-OM2400-5 12 ページ。 Collinear antenna kit

802.11 2.4Ghz Low-Power 5dBi Vertical Collinear Antenna

3/32in / 2.37mm brass tube feed element ( 3.60in / 90mm long )

11/32in / 8.75mm diameter brass tube decoupler (1.25in / 30mm long )

SMA Female PCB mount connector (round base, OD 0.31in / 7.95mm )

Black plastic radome end cap (OD 0.50in / 13mm )

Fiberglass radome

ARLX-OM2400-5 (8" / 20.32cm)

ARLX-OM2400-8 (19.5" / 49.53cm)

ARLX-OM2400-12 (34" / 86.36cm)

Instruction booklet with alignment cutout sheet

If any parts are missing, first double-check your unpacking and counting. If parts are still missing, please contact Aerialix

Note: The fiberglass radome is painted with a protective coating of black acrylic-urethane paint. If you would like to paint the

radome with another color of acrylic-urethane paint, first sand lightly with 220 grit sandpaper and apply the new coat.

Materials and Tools Required

The following are common mechanical and electrical tools and should be readily available to those persons with the skill level

required to build this kit:

Solder (rosin core)

electrical tape

Small Vise

50/50 Epoxy (most hardware stores carry this)

popsicle or other small applicator/mixing stick for epoxy

small disposable plastic mixing container ( ie: plastic cup )

dry cloth or paper towel

wire cutters

needlenose pliers

Soldering iron ( >60 Watt)

Ruler (Metric/english)

Measurements

Figure 4. Antenna segment measurements.

The schematic of the electrical components of the antenna is displayed in Figure 4. Note: this schematic is for a four element

Collinear array. The 1/2 wavelength and 1/4 wavelength measurements calculated above are to be applied to the various

elements in this schematic.