- ページ 4
アンテナ Aerialix ARLX-OM2400-8のPDF 建築マニュアルをオンラインで閲覧またはダウンロードできます。Aerialix ARLX-OM2400-8 12 ページ。 Collinear antenna kit
802.11 2.4Ghz Low-Power 5dBi Vertical Collinear Antenna
.
1
3/32in / 2.37mm brass tube feed element ( 3.60in / 90mm long )
.
1
11/32in / 8.75mm diameter brass tube decoupler (1.25in / 30mm long )
.
1
SMA Female PCB mount connector (round base, OD 0.31in / 7.95mm )
.
1
Black plastic radome end cap (OD 0.50in / 13mm )
Fiberglass radome
ARLX-OM2400-5 (8" / 20.32cm)
.
1
ARLX-OM2400-8 (19.5" / 49.53cm)
ARLX-OM2400-12 (34" / 86.36cm)
1
Instruction booklet with alignment cutout sheet
If any parts are missing, first double-check your unpacking and counting. If parts are still missing, please contact Aerialix
immediately at [email protected].
Note: The fiberglass radome is painted with a protective coating of black acrylic-urethane paint. If you would like to paint the
radome with another color of acrylic-urethane paint, first sand lightly with 220 grit sandpaper and apply the new coat.
Materials and Tools Required
The following are common mechanical and electrical tools and should be readily available to those persons with the skill level
required to build this kit:
Solder (rosin core)
electrical tape
Small Vise
50/50 Epoxy (most hardware stores carry this)
popsicle or other small applicator/mixing stick for epoxy
small disposable plastic mixing container ( ie: plastic cup )
dry cloth or paper towel
wire cutters
needlenose pliers
Soldering iron ( >60 Watt)
Ruler (Metric/english)
Measurements
Figure 4. Antenna segment measurements.
The schematic of the electrical components of the antenna is displayed in Figure 4. Note: this schematic is for a four element
Collinear array. The 1/2 wavelength and 1/4 wavelength measurements calculated above are to be applied to the various
elements in this schematic.
(C) Aerialix 2002 (4 of 13)