- ページ 2
ロックス CAMDEN CX-EPD1289LのPDF 取付説明書をオンラインで閲覧またはダウンロードできます。CAMDEN CX-EPD1289L 7 ページ。 Electric preload rim strike
ページを印刷するCX-EPD1289L Electric Preload RIM Strike
INSTA L L AT I O N I NST RU CTI ONS
4. INSTALLATION
Introduction
RIM electric strikes, used with Pullman latch devices
(i.e. exit devices) are very different from installing an electric
strike for cylindrical or mortise lock sets, and therefore require
additional considerations and a different installation technique.
Step 1: Using the Install Jig
1
Note:
1. Open door slightly. Place template on door jamb
aligning templates edge with jamb edge.
3
Note:
1. Open door slightly,
and remove the template.
Page 2 of 7
Camden CX-EPD1289L is designed to provide up to 15 lbs of
preload on the strike keepers. This unique feature eliminates
typical installation challenges caused by warped or misaligned
doors, frames or locking hardware.
Align template edge with
the jamb edge
(Note : While aligning the
template with the Jamb
edge, If the door keeper
does not align with the
template cavity, Adjust the
template)
Note:
1. Close door making sure template is in place.
Align Crash bar latch with template latch hole.
2. Mark holes center on the frame with a pencil or marker
3. While aligning the template with the Jamb edge, If the
door keeper does not align with the template cavity,
Adjust the template
4
A
Hole punch
B
Holes for
self-tapping
screws
A
Hole punch
Note:
1. Use a hole punch on marked positions.
2. Use drill size 5/8" to drill hole B.
3. Drill and tap holes A for 1/4-20x1-1/4" screws.
2
Marker/
Pencil
Closed
Door
Crash
Marker/
Bar
Pencil
Door Jamb
5
Jamb
Connecting
5
wire hole
''
Connecting
Ø
8
wire hole
Jamb
5
''
1
8
3
''
8
8
4 3
''
5
''
16
Ø
8
4 3
''
16