- ページ 3
レシーバー CAMDEN Lazerpoint RF RX-90のPDF 取付説明書をオンラインで閲覧またはダウンロードできます。CAMDEN Lazerpoint RF RX-90 7 ページ。 Advanced single relay receiver
ページを印刷する
Lazerpoint™ RF RX-90 Advanced Single Relay Receiver Installation Instructions
Adjust POT1 clockwise until the LED starts to flash. The RX-90
is in latching mode at this point. To remove latching mode,
turn POT 1 counter clockwise until the LED is solid again.
Note: Latching mode disables delayed mode. Transmitter
programmed as delayed mode will work as latching mode
transmitter.
Step 3
Deleting Transmitters
Delay Mode Transmitters
Set SW1 to ON.
Pressing and holding PB1 for 8 seconds will delete all
transmitters delay mode. The LED will flash rapidly for 4
seconds to indicate erasure of the codes.
No Delay Mode Transmitters
Set SW1 to OFF.
Pressing and holding PB1 for 8 seconds will delete all
transmitters no delay mode. The LED will flash rapidly for
4 seconds to indicate erasure of the codes.
Note that individual removal of specific codes is not possible
at this time.
Section 5
Technical Data
Model
Size
Mounting
Enclosure
Operating Voltage
Current Draw
Response Time
Memory Delay & No Delay 40 transmitters total
LED's
Output
Rating
Operating Time
Delay Time
RX-90 Receiver
2 5/8"H x 1 1/2"W x 13/16"D
(67mm x 38mm x 21mm)
2 # 4 screws at 3" centers,
or Velcro (supplied)
Clear plastic case
12 / 24 Volts, AC / DC
23 mA nominal @ 24 VAC
43 mA maximum @ 24 VAC
30 – 200 ms
Indicate: relay status;
learn mode; erase mode &
potentiometer position
1 x SPDT Relay contact
3 amps @ 30 VDC
1 – 30 seconds
1-15 seconds
Electrical Life
Temperature Rating
Certifications
Section 6
Warranty
Camden Door Controls guarantees the Lazerpoint RF to be
free from manufacturing defects for 3 years from date of
sale. If during the first 3 years a Lazerpoint RF component
fails to perform correctly, it may be returned to our factory
where it will be repaired or replaced (at our discretion)
without charge. Except as stated herein, Camden extends
no warranties expressed or implied regarding function,
performance or service.
NOTE: Batteries are exempt from this warranty!
1 x 10
minimum
5
-40 to 185°F (-40 to +85°C)
- FCC Part 15 Compliant
- Canada RSS CNR210:1078
1032 061A
- Meets: IEC60601-1-2:2007
- Patent Pending
Page 3 of 7