- ページ 4

3Dプリンター 3D Upfitters Temp SensorのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。3D Upfitters Temp Sensor 11 ページ。

Mounting the Case

Installation depends on what exactly you want to do with the touchscreen. The ﬁrst release has

two separate temperature sensors on long wires. The simplest thing is to lay the touchscreen

on the table for testing purposes and use a cable access port to bring the cables inside the

enclosure. However, the air quality VOC meter should be close to the top of the enclosure to

get a good reading. We've had good luck mounting the case near the top of the sides on the

left or right.

If you purchase a 3D UPﬁtters enclosure, it will come pre-cut to place the touchscreen case at

either the top left or top right near the front.

If you'd like to mount the touchscreen on your enclosure, the STL for a drill template is

available at the bottom of the main product page. The holes labeled S1 and S2 will enable you

to bring the sensor cables into the enclosure hidden behind the case for a cleaner look.

Note that holes will be added to the fan controller in future versions. While we don't like having

to drill holes, this is the least bad of the available solutions. We will make every eﬀort not to

change the holes' location; future directions force later versions to not be compatible with this

hole pattern. If you are squeamish about leaving holes in your enclosure, you'll probably want

to wait until later versions are released in the latter half of 2022.