- ページ 5

計測機器 abc 4T2 bmp 3000のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。abc 4T2 bmp 3000 15 ページ。 Broadcast multi probe

1.5 Safety remarks

This manual addresses qualified personnel being familiar with the relevant safety standards in RF-

measurement techniques.

It is recommended to install and operate the 4T2-Broadcast Multi Probe by qualified personnel

only.

Maintenance of the 4T2-Broadcast Multi Probe instrument shall be performed by qualified ABC

personnel only.

The measurement instrument shall be used only for the range of operations mentioned in

this manual. Please adhere to all mentioned data. The product has been developed and

manufactured according to all relevant safety standards. Observing the instructions for safety

and operations mentioned in the manual using the instrument does not cause any hazardous

situation for man or matters. Unqualified operations on hard- and software as well as

neglecting the safety hints fixed to the device may lead to personal or material damage.

Additional or extensional devices to the 4T2-Broadcast Multi Probe may only be used if

recommended by ABC.

Any other usage or operation from the one mentioned in the manuals will be treated as not

agreed.

All relevant safety and accident prevention instructions have to be observed during

commissioning, operation and maintenance.

All safety regulations and accident prevention instructions according to the specific

operation scenario have to be observed. Opening of the 4T2-Broadcast Multi Probe is not

allowed and voids the warranty.

Regular checks have to be done in order to verify that the power cable connected to the

instrument is in good condition. In case of a power cable problem, the cable has to be

removed from mains immediately and the defective cable has to be replaced.

Do not attempt to power the instrument from any receptacle other than a 2 pole 3-wire

grounded receptacle.

Before setting into operation, check for conformity between the allowed voltage range and

the mains provided by the local power supply.

Do not place the instrument close to liquids, don't allow liquids or any foreign objects to get

inside.

Do not place the instrument in direct sunshine or close to strong heat-emitting sources.

Do not block air vents in the back, or on the front of the instrument and the attached Tablet

computer.

4T2-BroadcastMultiProbe bmp3000 ManualEN.odt

Page 5