レシーバー abc GE-8 Starguide IIIのPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。abc GE-8 Starguide III 9 ページ。

ABC GE-8 STARGUIDE III SATELLITE RECEIVER

PLEASE REVIEW THIS QUICK START GUIDE IN ITS ENTIRETY

BEFORE INSTALLING YOUR RECEIVER.

• It is critical to make all satellite RF and audio connections prior

to applying AC power to the Starguide receiver.

• The Starguide III receiver must be powered down before you

install or remove any option cards located in the expansion

ports. None of the cards in the receiver are "hot-swappable".

• ABC strongly recommends the use of a Phase Lock Loop (PLL)

LNB for your new Starguide receiver. The Local Oscillator (LO)

stability of your LNB should not exceed 100kHz.

• If this receiver is designated to supply DC power to the LNB at

your dish, be sure to turn on the LNB VOLTAGE switch on the

back of the receiver.

• ABC urges stations to use an Uninterruptible Power Supply

(UPS) for the Starguide receiver for equipment protection from

power spikes or brownouts. Also consider lightning protection

if you are located in an area susceptible to frequent lightning

storms. A surge suppressor is not sufficient.

• The ABC Radio Networks New York Technical Services office is

staffed Monday-Friday from 9:00am until 5:00pm ET for

receiver authorization and technical assistance.

sg3_QS_GE8 03/22/01

QUICK START

(212) 456-5000 – option #4

(212) 456-5708 – fax

Page 1 of 1