- ページ 5

楽器アンプ Acoustic Image Flex CabのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Acoustic Image Flex Cab 12 ページ。

ページを印刷する

Speaker Placement

The omnidirectional low frequency output of our speaker cabinets

makes speaker placement relatively noncritical. You will easily be

heard all over the bandstand no matter where one or more arelocated.

However, best results are obtained when the cabinet is placed on the

floor. Putting the unit on a shelf or stand will reduce bass frequencies.

There may be circumstances where this is desirable. Feel free to

experiment to find the sound that is best for you.

Tilt Mechanism

In some settings, such as a hollow stage or small, "boomy" room, your

amp or enclosure will produce too much bass. One way to cut

unwanted bass output is to use the built in tilt back feature to lift the

front of the cabinet, reducing the coupling to the floor. To do this, pull

the stand into its forward position and set the combo in place on the

floor. The stand is spring loaded so when you pick up the unit, the

stand will spring back into its storage position. You may want to use

the tilt stand at all times in order to aim the high frequency output of the

speaker toward your ear so that you can better hear the amp.

Slip Cover and Shoulder Strap

The supplied slip cover is fitted to the Flex Cab. To install it, slip it over

the top of the cabinet and line up the holes in the cover with the handle

openings on the cabinet.

To use the shoulder strap to transport the cabinet, feed the strap

through the handle opening on both sides and clip the end to the D-

ring attached to the strap. The picture below illustrates how to attach

the strap. The strap can be used either with the slip cover in place or

not in place.

Note that there are powerful magnets in the vicinity of the

recessed screws in the top of the Flex Cab. Do not place anything

on the top that will be damaged by the high magnetic field. Smart

phones, tablets, laptops, digital recorders, etc. should not be

placed on the top of the cabinet.

Specifications-Flex Cab

System

Frequency Response

30 Hz-18 kHz (40 Hz-14 kHz ±3 dB)

Max SPL

118 dB/m

AC Power

100V to 240V (50/60 Hz), automatically

switched

Size

14"Hx15"Wx13"D

Weight

32 lbs

Electronics

Flex Pre Interface

Balanced signal, power and ground

through RJ-45 connector, Cat5 cable

Input Connector

10k ohm impedance, unbalanced, line

Thru Connector

10 k ohm impedance, unbalanced

DF Filter

30 Hz to 150 Hz, 12 dB/oct, sweepable

DF Level Control

0 dB, -6 dB, switchable

Tweeter Level Control

-10 dB to +6 dB

Woofer Power Amps

2 at 300W rms each, class D

Tweeter Power Amp

50W rms, class D

Speaker System

Woofer

Dual 10 inch, one downfiring, one

forward firing

Tweeter

2.5 inch

Crossover

Active, 12 dB/oct

Supplied Accessories

Fitted slip cover with shoulder strap

Available Accessories

Padded gig bag with shoulder strap

made by Mooradian

level signal