- ページ 8

おもちゃ 3DHobbyShop.com Yak 54のPDF 組立マニュアルをオンラインで閲覧またはダウンロードできます。3DHobbyShop.com Yak 54 18 ページ。 55” arf rc aircraft

Prepare the elevator halves. Install the control horns into the bottom of the elevator halves just as you

installed the horns into the ailerons.

Insert the elevators into the horizontal stabilizer. Check for alignment and free motion of the elevators.

Because good 3D flight requires extreme elevator throw, leave a small (1-2mm) gap between the

elevators and horizontal stabilizer to allow maximum throw. Apply two large drops of thin CA glue to each

hinge. Do not use less than two large drops.

Install your servo extensions onto the elevator servos.

Install the elevator servos as shown in each side of the fuselage.