- ページ 11

ドローン Aerix DaVinciのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Aerix DaVinci 16 ページ。

3. Wait until the aircraft's lights stop flashing rapidly. This is an indication

that the calibration was successful (the back light on the aircraft flashes green).

Attention: the aircraft should be placed on a flat surface; during the

calibration procedure do not move the aircraft.

Attention: if the back light of the aircraft flashes red-green-blue then

accelerometer calibration is needed.

4.Arming and Disarming Motors

Arming: after successful pairing, arm the motors by pushing both

sticks at the same time (push the left stick to the bottom-left corner and the

right stick to the bottom-right corner) and hold for 2-5 seconds and the

motors will start spinning. Slowly push the throttle stick up and the aircraft

will ascend.

Disarming: after descending the aircraft, disarm the motors by

pushing both sticks at the same time (push the left stick to the bottom-left

corner and the right stick to the bottom-right corner) and hold for 2-5 seconds,

the motors will stop spinning.

Arming/disarming motors

Attention：the aircraft should be placed on a flat level surface; the back light

of the aircraft should be slowly flashing green。