ページを印刷する
I N S T A L L A T I O N
A N D
I N S T R U C T I O N
M A N U A L
SETUP AND INSTALLATION
Unpacking
Remove the CHALICE lighting fixture from its shipping box. Set the unit down on a flat surface before
proceeding. Remove the top six screws, lift the light engine assembly straight out and remove protective
shipping paper between the front lens and LEDs. If needed, remove stock lens and install any other accessories
like a snoot, louver, spread lens etc. at this time. Insert the accessory to the (3) lens clips provided on the front
of the unit. Once all the accessories are installed, reinstall the light engine assembly straight in and tightly screw
back in place using the same six screws.
Lamping and Re-lamping
The CHALICE lighting fixture is provided with an integral LED light engine. Under normal operating
conditions, the LED light engine should have a rated life expectancy of over 50,000 hours. There are no user
serviceable parts inside. The entire LED assembly will need to be changed.
Mounting the fixture
Install the provided canopy kit to a proper weight load bearing junction box. For slant ceilings, make sure you
have purchased the canopy kit designed for slant ceilings.
Connecting power and data to the fixture
Wire the fixture to a properly grounded circuit breaker. Note: Black or Brown = LIVE; White or Blue =
NEUTRAL; Green or Green/Yellow Stripe = GROUND. For DMX models, there will be two CAT5e or
equivalent Ethernet cables provided for DMX in and DMX out connections. They will be properly marked.
For each CAT5e data cable, White/Orange = DATA+; Orange = DATA-; White/Brown and Brown = COM
connection to a standard DMX512 data control signal.
Focusing the fixture
The canopy and stem kit is provided with about a 360 degree rotation limit stop. This allows the use of
accessories including lenses, snoots, louvers, spread lenses, etc. With the fixture energized, rotate the down light
to the desired beam location. The optimum distance for best results is 5 to 10 feet away from the projection
surface.
Cleaning the fixture
Routine cleaning of the CHALICE lighting fixture will provide years of prolonged use. Use compressed air to
blow off any dust and dirt from the lens, reflector, electronics and heat sink. For the lens, use a soft lint-free
cloth dampened with water to clean the lens of dust and dirt. Dry off completely with compressed air or a dry
lint-free cloth.
ETL FILE LISTING
The CHALICE lighting fixture is ETL and c-ETL listed under Altman File 9700680 for Electric Luminaires.
4