- ページ 13
自動車アクセサリー Camec Elite Pro2 EM305のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Camec Elite Pro2 EM305 20 ページ。 Caravan mover
ページを印刷するOPERATION - MOTOR UNITS
The manoeuvring system has two motor units (1 & 2). In general they are mounted in front of the axle of the caravan.
Both units are identical but cannot be switched.
Traction indicator label:
The yellow-green-red traction indicator label (Fig. 12A), on the side of each motor unit indicates if the roller is
depressing the tyre sufficiently to provide adequate traction.
If the pointer is in
Rollers are not touching or
the YELLOW area
depressing the tyre sufficiently
If the pointer is in
Rollers should be connecting
the GREEN area
correctly to the tyre (margin of
15mm)
If the pointer is in
Rollers are connected to the
the RED area
tyre but in an extreme position.
It could be that the tyre of the
caravan has insufficient air
pressure or the drive unit has
been knocked out of position
and a visit to a workshop is
required to reposition the
assembly
Disconnect the motor powered rollers in case of emergency:
In the case that the caravan battery is discharged too far to automatically take
the motor powered rollers off the tyre, or there is a defect, you can also do this
manually. See figures 13 & 13.1.
•
Take the plastic cap (Fig. 13B) at the rear side of the housing off the motor
for the automatic engaging system. If necessary use a screwdriver.
•
Place the emergency key (6) on the emergency socket in the motor unit
(Fig.13A & 13.1C) and turn it until the motor unit including motor powered
rollers are in the beginning position.
•
Repeat this also on the motor unit on the other side.
•
Put the plastic caps back on the motor housing.
As soon as the battery is charged again, or the problem is solved, the motor
powered rollers will automatically work again.
CAMEC ELITE PRO
2
®
A.
Aluminium drive roller
B.
Drive unit, including 12V motor
C.
Plastic motor cover
D.
Base unit
E.
Gear cover
F.
Motor for automatic engaging system
Ref: ELITE PRO 2 EM305-0715Rev.A.
EM305
13