- ページ 8

録音機器 Alto L-6のPDF オウンズ・マニュアルをオンラインで閲覧またはダウンロードできます。Alto L-6 19 ページ。 6-channel mixing console with digital effects

4 AUX SEND

This 1/4" phone socket is used to send out the signal from the AUX bus of the

input channels into external devices such as effect units and/or stage monitors.

The AUX SEND is wired post-fader to control the signal of the internal

multi-effects unit. You can also connect an external effect unit. In such case,

the internal effect unit will be automatically disconnected. If you want to wire

the AUX circuit as pre-fader, read Chapter 6. of this Manual. In the pre-fader

mode, the AUX bus can send the signal to a stage monitor.

5 STEREO AUX RETURNS

You can use these stereo 1/4" phone sockets to return the stereo signal of an

effect unit to the Main Mix. Alternatively you can use them as an extra auxiliary

input and using the AUX RETURN level control as volume control. The signal will

be sent directly to MAIN MIX control.

6 CTRL ROOM OUTPUT

These 1/4" phone sockets will be used to send the signal to a pair of powered

Studio Monitor speakers or to a second set of PA.

7 MAIN MIX OUTPUTS

This stereo output is controlled by the Main Mix Level on the Master section

and will send the audio signal to an amplifier or to a pair of active speakers. The

output level can be varied from -

8 TAPE IN

Use the Tape input to connect a CD Player, Tape, DAT, iPOD or any other line-

level source. You can send this signal either to CONTROL ROOM OUTPUT and/

or to the MAIN MIX OUTPUT using the relative 2TK TO select buttons.

9 TAPE OUT

These RCA jacks will route the main mix signal into a tape or DAT recorder.

10 PHONES

This socket will be used to send the signal to a pair of headphones.

CHANNEL STRIP

11 LEVEL

This knob controls the channel's level from -

12 PEAK LED

This red LED will let you know about the status of the signals processed into

your L-6. Connect a microphone or an instrument to your L-6 and sing/play at

normal volume. Set the level control of that channel so that the PEAK LED

lights-up only occasionally. If this LED is always on, you are experiencing a lot

of distortion and you should turn the TRIM control down or reduce the EQ

boosting. If this led never lights up, turn the TRIM control up again.

4. CONTROL ELEMENTS

to +15 dB.