- ページ 7

ドローン 3DR Y6のPDF 組立マニュアルをオンラインで閲覧またはダウンロードできます。3DR Y6 13 ページ。
3DR Y6 にも：クイック・スタート・マニュアル (8 ページ)

ページを印刷する

1. Contents of the Kit

IN STAL L AP M

Mount APM

Place APM 2.6 in the center of the APM plate

with the arrow on the case facing forward

(toward wide end). Use four adhesive

foam squares to secure the bottom of the

case to the plate (one on each corner).

Ensure APM and foam squares are firmly

attached so the position of APM does not shift during flight.

For APM 2.5: Mount APM to the top of the accessory plate.

APM plate

Connect APM to power module and PDB

Locate the PDB six-wire cable (multicolored) and the power module six-position cable (red

and black); thread these cables up through the slots in the APM plate where they can connect

to APM.

PDB wire

positions

APM plate

35 mm bolt + thumb nut

Mount GPS

Place the GPS module onto the square end of the accessory

plate with the arrow pointing towards the center of the plate. Use

double-sided foam tape to secure case to plate.

Using the four holes shown across, insert a 30 mm

threaded spacer over each hole and secure from

below with a 5 mm nylon bolt.

5 mm nylon bolt + 30 mm spacer

APM output

pin positions

PDB to APM wiring

The APM plate connects to the ends of the three 35 mm bolts

securing the inside holes of the arms. Place the three outer holes in

the APM plate over the exposed 35 mm bolts on the top plate and

secure with thumb nuts.

Ensure arrow

on APM points

forward!

Connect the power module six-position cable

(red and black) to APM's PM port. Connect the

PDB six-wire cable (multicolored) to the APM

output signal pins (top row). Ensure that the

individual PDB wires are connected to the

corresponding APM output signal pins. For

example, the wire originating in the position

marked M1 (motor 1) on the PDB must connect

to APM output signal pin 1.

3DR APM 2.6

APM plate

Accessory plate

Ensure arrow on

GPS points forward!