- ページ 11

ランタン BALTENSWEILER HALO LED SのPDF 取付・取扱説明書をオンラインで閲覧またはダウンロードできます。BALTENSWEILER HALO LED S 16 ページ。
BALTENSWEILER HALO LED S にも：取付・取扱説明書 (5 ページ)

Protection classes, safety regulations and instructions

The luminaire may only be used with a mains voltage of 220-240 V 50/60 Hz. For mounting, observe the

statutory installation and safety regulations. Always disconnect the power supply when carrying out installa-

tion, cleaning or maintenance tasks. Repairs may only be carried out by the manufacturer or by a qualified spe-

cialist in accordance with the applicable standards. In the event of incorrect installation or that the luminaire has

been tampered with, all warranty claims shall be rendered invalid, as will the manufacturer's product liability

obligation in accordance with the European Directive concerning Liability for Defective Products (85/374/EEC)

and the Swiss Federal Law on Product Liability (PrHG). BALTENSWEILER shall assume no liability for any loss

or damage to persons or property caused by improper handling or non-adherence to the safety regulations!

Only touch the luminaire head at either of its ends during operation - The reflector area gets very hot. The

luminaire must not be loaded and equipped with objects that are not part of the product (risk of breakage /

falling), and must not be covered with objects (e.g. textiles) during operation (fire hazard). Keep protective glass

and LEDs free of dirt and foreign particles (follow the care instructions). Such impurities can lead to increased

heat generation which can damage the luminaire.

LEDs are permanently installed and may only be replaced by the manufacturer.

Small magnetic components are installed in the luminaire. Magnets may affect the function of pacemakers or

implanted defibrillators.

Recommended safety distance from the magnet:

85 mm for new versions with a max. permitted magnetic field of 1 mT = 10 G.

105 mm for old versions with a max. permitted magnetic field of 0.5 mT = 5 G.

You will find further information on: www.baltensweiler.ch/service/faq/

Do not shine the LEDs directly into eyes!

Electronic components are sensitive to electrostatic discharge and can be destroyed if the connections are

touched. Suitable protective measures against ESD (Electro Static Discharge) must be taken.

External dimmers (including wall-mounted dimmers) are NOT permitted and can damage the LEDs and the

control gear.

Care instructions: Disconnect the power supply. Wipe with a damp cloth. Do not use abrasive, alcoholic or

electrostatically charged cleaning utensils. Do not touch or clean the LED (mechanical / chemical / electrostatic

damage to the LEDs).

The luminaire may only be installed in dry interior spaces.

Correct disposal / Luminaire must not be disposed of wit the normal household waste.

Protection class II:

Equipment with protection class II has reinforced or double insulation between the active and accessible parts

equal to the rated insulation voltage.

Protection class IP20:

IP20

Protection against contact with fingers and medium-sized solid foreign bodies ø ≥ 12 mm.

Technical conformity in accordance with EN directives.