- ページ 2

電子タバコ Divine Tribe Ceramic Donut v3のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Divine Tribe Ceramic Donut v3 2 ページ。

Divine Tribe v3 Ceramic Donut Atomizer Quick Start Guide

Usage and cleaning notes

There is a "break-in" period for a new/ clean donut - load slightly more during this time (first 5-10 loads)

●

There is a "sweet spot" where new loads and reclaim are balanced

●

unpowered cool down hit. Holding your mod upside down after a hit will let the reclaim drop down on the bottom of the donut for vaping. Holding

the atomizer at a slight angle and rotating in a circle while hitting it will help the hot oil touch the bottom of the donut and vaporize.

Once past the "sweet spot" the excess reclaim must be removed. I use a tightly rolled up paper towel for this. Roll the paper towel like a

●

cigarette (flat end) and insert into the atomizer. Hold it upside down and fire it to heat the reclaim. You can assist this process by blowing

through one air intake while covering the other. Rotate the paper towel to clean the walls too. Finally, re-roll the paper towel with a pointed end

and work the center and sides of the donut soaking up most of the reclaim. This will extend the time between break down cleanings.

Eventually a full break-down cleaning will be required as the donut will have some buildup and taste will be affected. New donut/ cups are cheap

●

and you can save time by just q-tipping the base and replacing the donut and cup, but you can also clean donuts and cups to original condition

and use them for 6 months or longer.

Matt has an excellent video on cleaning using your mod -

●

I clean with isopropyl alcohol (ISO) and a torch. First note the cold resistance of your atomizer

●

Remove the outer cover from the base by removing the three screws and wipe down the mouthpiece and base cover. Carefully separate the

donut and cup by removing the two post screws. Straighten the leads with a needle nose pliers and carefully slide the donut out of the cup.

This takes some finesse because reclaim will lock the leads in the holes. Put the cup back in the ISO and gently grab the donut leads with a

locking pliers and use a torch to burn the crust off the donut. Move the torch frequently and do not cherry the donut

off any buildup. While the donut cools, torch the cup until clean. When all parts are cool, reassemble the atomizer and check that the cold

resistance has not changed. Treat yourself to a nice dab on a clean donut.

A little bit of coconut oil makes a great lubricant for the mouthpiece o-rings.

●

ineedhemp.com 2017

–

https:/ /www.youtube.com/watch?v=P6RuAjzqY_A

using cool down hits can extend this time. Finish each session with a full

–

it should not change with this procedure.

the goal is just to burn

–