- ページ 7

3Dプリンター 3DUpFitters CR-10 Smart Enclosure KitのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。3DUpFitters CR-10 Smart Enclosure Kit 19 ページ。

Assemble Panels

1. Attach The Front Door Frame Corners 

Each of the corners on the enclosure will be held together by the connectors pictured

below. There are only two versions L and R, which can be identiﬁed by the letters

stamped on the inside. The opposite connectors are identical, i.e. Bottom Right is the

same as Top Left. In all cases the surface of the connector with the cutout pattern

faces front or back.

The front door is designed so that the latches are on the right when viewed from the

outside. Attach the corner connectors on the back side of the door frame using the

provided cap head M4 12mm screws. See the photos below. The top of the connector

should be ﬂush with the top of the acrylic.

Top Left

Bottom Left

View from the back of front panel

View from the front of the front panel 

Top Right

Bottom Right