- ページ 9

IPカメラ Divio Full HD Ultra-WDRのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Divio Full HD Ultra-WDR 19 ページ。 Full hd speed dome ip camera

2.1

Power Connection

To power up the camera, connect the AC 24V power adaptor to the power

connector of the camera and the power outlet. Please refer to the diagram and

the pin definition table below for connection. Alternatively, users can use High

Power over Ethernet (PoE+) to power up the camera if an IEEE 802.3at 60W

PoE+ switch is available. Refer to the section below for Ethernet cable

connection.

2.2

To have best transmission quality, cable length shall not exceed 100 meters.

Connect one end of the Ethernet cable to the RJ-45 connector of the camera,

and plug the other end of the cable to the network switch or PC.

Check the status of the link indicator and activity indicator LEDs. If the LEDs are

unlit, please check the LAN connection.

Definition

AC 24V 1

GND

AC 24V 2

NOTE: In some cases, Ethernet crossover cable might be needed when

connecting the camera directly to the PC.

Green Link Light indicates good network connection.

Orange Activity Light flashes for network activity indication.