- ページ 8

エンクロージャー 3DUpFitters Prusa i3 MK3のPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。3DUpFitters Prusa i3 MK3 11 ページ。 Enclosure kit
3DUpFitters Prusa i3 MK3 にも：インストレーション・マニュアル (18 ページ)

ページを印刷する

the enclosure. If attaching the fan by itself use 16mm

cap head screws; if attaching the ﬁlter and fan use M4

cap head 30mm or 40mm screws depending on the

depth of the particular fan.

The air ﬁlter should look like this after being attached.

Note that it's easier to insert the screws from the

inside, and put the nuts next to the ﬁlter housing.

Now attach the back to the left and front panels,

which should look like the illustration to the right.

Note the picture shows the ﬁlter hole cover in place.

4. Attach Top

Be careful when taking the plastic cover oﬀ of the

top, as the area around the ﬁlament slit is delicate

if bent the wrong way.

The top has a front, back, and left to right. This is

because it overhangs the front which is twice as

thick. The right side of the ﬁlament slit is closer to the

right edge than the left. Use access through the

doors to attach the top of the enclosure using M4

10mm screws. If you attach the top and there's overhang in the back, then it's attached

backwards.

The MMU2S version adds to rubber grommets that are not shown in the above image.

5. Attach Right Side

The purpose of the vent on the right side is to bring

cooler air to the power supply to increase its longevity

under heavy use. With the fan and/or carbon ﬁlter in

place cold air will be drawn in through the power