- ページ 2

コントローラー 3E THERMOSALD ISCのPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。3E THERMOSALD ISC 20 ページ。 Temperature controller for impulse sealing. modular system

ページを印刷する

WARNINGS

THIS BOOK IS SUPPLIED WITH OUR PRODUCT AND DESCRIBES THE FUNDAMENTAL FUNCTIONS

EMPLOY QUALIFIED AND WELL-TRAINED PERSONNEL, FAMILIAR WITH THE TECHNOLOGY USED

TO INSTALL OR MAINTENANCE THE EQUIPMENT, CONSULTING MAINTENANCE & OPERATIONS

MANUAL.

0.1 SAFETY PRECAUTIONS

- Never use the equipment in explosive atmospheres or with explosive materials.

- Never use the equipment with flammable material without first taking the required

safety precautions.

- Operate the equipment by following the instructions contained in this

MAINTENANCE & OPERATIONS MANUAL before doing an installation.

- Never turn on the temperature controller power circuit when the safety guards are

open.

- Do not use the temperature controller for tasks other than those it is designed for i.e

to control the temperature of bands or wires for industrial-grade sealing. Contact our

engineering department for information regarding specific applications.

- Do not deliver electrical power to the temperature controller if the protective cover

has been removed for special servicing on the electronic system.

- Employ qualified and well-trained personnel familiar with the technology used, to

install and use the equipment.

- Grounding the thermoregulator by yellow-green cable connected to the predisposed

screw and by 4 fixing screw.

- Use bands or wires having an adequate positive temperature coefficient >900 PPM (

900 part per million, > 900 x 10E-6)

- When the machine is running under normal conditions, make sure the heat sink of

the controller does not exceed 60°C . If this happens, increase heat sink ventilation

or contact our engineering department.

- When the sealing bands are in parallel pay attention at the connections of the cables

that must not be crossed; with the correct connection the current flow in both sealing

bands in the same direction and all the points opposite of the sealing bands have the

same voltage and in the case of an accidental contact it is not possible having a short

circuit between sealing bands and a high current. Viceversa if the sealing bands

touch ground, possible case, the thermoregulator blocks up the current immediately.

THERMOSALD ISC – MANUAL QUICK START

Manual cod.: 3ES080x_V5.1_QS_EN

Includes all previous models

Page Nr.

Rev. 2010 / 03

Tot. Nr . 20