- ページ 6
フードウォーマー Alto-Shaam HFM-30のPDF マニュアルをオンラインで閲覧またはダウンロードできます。Alto-Shaam HFM-30 18 ページ。 Hot food module electric
Alto-Shaam HFM-30 にも： パンフレット (4 ページ), 仕様 (2 ページ), インストレーション オペレーション＆メンテナンス (17 ページ)
ページを印刷する
W A R N I N G
Improper installation, alteration,
adjustment, service, cleaning, or
maintenance could result in property
damage, severe injury, or death.
READ and UNDERSTAND the
installation, operating and
maintenance instructions thoroughly
before installing, servicing, or
operating this equipment.
W A R N I N G
Appliance and accessories may be
heavy. To prevent serious injury,
ALWAYS use a sufficient number
of trained and experienced workers
when moving or leveling appliance
and handling accessories.
S I T E I N S T A L L A T I O N
The hot food module must be installed on a stable
1.
and level surface free of vibration and suitably
strong enough to support the combined weights of
the unit plus the maximum product load weight.
Peel the protective film from the VHB tape located
2.
on the inside flanges of decor face. Press decor
face (control) up against the mounting surface.
Level the appliance from side-to-side and
3.
front-to-back with the use of a spirit level.
4.
Follow solid surface material manufacturer's
instructions for its installation.
In order to maintain standards established by
5.
the National Sanitation Foundation, all edges
must be sealed to the heated module with NSF
approved sealant.
I N S T A L L A T I O N
MN-35698 (R
. 4) 09/15 • HFM SERIES MERCHANDISER • 4
ev
C A U T I O N
To prevent SEVERE PERSONAL
INJURY or PROPERTY DAMAGE:
ALWAYS use hand protection when
operating this appliance to avoid
burns. Metal parts of this equipment
become extremely hot when in
operation.
W A R N I N G
FOR YOUR SAFETY
DO NOT store or use gasoline or
other flammable vapors or liquids in
the vicinity of this or any other
appliance.
CLEARANCE REQUIREMENTS
6" (152mm) from bottom of appliance.
INSTALLATION REQUIREMENTS
• Unit must be installed level.
• It must not be installed in any area where it
may be affected by steam, grease, dripping
water, high temperatures, or any other severely
adverse conditions.
• Customer supplied solid surface material must be
rated to withstand temperatures of 300°F (148°C).
Material must be 3/4" (19mm) thickness, 3/8"
(10mm) radius corners and 1/8" (3mm) top and
bottom edge. Edges must be polished. Contact
Alto-Shaam for additional information.
"Z" Dim. ±
1/16" (2mm)
DETAIL A
A
R.125 (3.18) Radius