- ページ 18

サーモスタット ESI ESRTP4RFのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。ESI ESRTP4RF 20 ページ。 Rf programmable room thermostat
ESI ESRTP4RF にも：取付説明書 (20 ページ)

To operate the copy function

1. Switch the slider to PROG and press the

Button.

2. Press the C button to enter the COPY mode.

3. The A button chooses the day you want to copy from and

the +/- buttons choose the day you want to copy to.

4. Press the C button to confirm. The screen will show SEr

(to show the Copy function is set).

Battery Replacement

4.3

When the low battery symbol flashes in the LCD display, the

batteries need to be replaced as soon as possible. The battery

compartment is located on the front of the thermostat, under

the fascia cover. Remove the old batteries and insert new

ones. All settings including time are maintained.

N.B. If the display ever goes blank during normal operation,

the batteries need to be replaced with high quality

alkaline cells. The date, time and factory pre-set heating

times will be retained (assuming the back up battery has

not failed).

4.4

To reset the programmer, hold reset for approx. 3 seconds.

The system and programme will restore to the factory default

settings. Hold the Next

to restore to factory default settings.

It is possible to operate the receiver manually. This may be

necessary where, for example, the batteries in the Thermostat

(Transmitter) are depleted and therefore the heating cannot

turn ON or OFF.

button and press the reset button

Home