- ページ 3

室内装飾品 ESI Enmo 2NM-C48-WHTのPDF 組立・取扱説明書をオンラインで閲覧またはダウンロードできます。ESI Enmo 2NM-C48-WHT 12 ページ。 Electric height adjustable table base

Enmo

Step #1: adjust frame width

• Place the worksurface facing down on a soft, clean surface.

• Center the frame front to back on the worksurface.

• Adjust the width of the frame.

— Use the 4mm Allen key to loosen all eight pre-installed M6x10

screws in the cross channels.

— Expand the frame so that its ends are 2" to 3" from

the edges of the table.

— Tighten the M6x10 set screws to hold

the width.

Step #2: attach the legs

• Place the legs next to the frame, adjacent to their future location.

• Lower the frame over the legs so that the base of the legs fit in the opening between the end of the frame

and the first cross support.

— Fit the openings in the cross supports over the motor cables.

• Attach each leg to the frame with four M6x12 screws per leg, as shown.

lower frame over legs

openings ﬁt over motor cables

M6x10

(pre-installed)

2" to 3"

Page 3

4mm Allen key

M6x12

4mm

Allen key

Assembly

2" to 3"