- ページ 2

室内装飾品 ClearMirror Shower ClearMirror SeriesのPDF 取付説明書をオンラインで閲覧またはダウンロードできます。ClearMirror Shower ClearMirror Series 6 ページ。 Fog-free shower mirrors

NOTICE: All installation wiring must be performed by a licensed electrician. Follow the National

Electrical Code, local codes, NFPA 70-2011 as applicable.

NOTICE: Only use the power supply included with this product.

NOTICE: All wiring including new receptacles, must be performed by a licensed electrician.

Follow the National Electrical Code or local codes as applicable.

WARNING: Direct plug-in power supply must be placed in a dry location outside of the shower.

Outlet used must be at least three feet from the shower. Follow NEC Article 406. Failure to

follow instructions could result in death or serious injury.

General Guidelines

• Extreme caution is necessary when any heater is used by or near children or invalids and

whenever the heater is left operating and unattended.

• Do not operate any heater after it malfunctions. Disconnect power at service and have heater

inspected by a reputable electrician before reusing.

• Do not use outdoors.

• To disconnect heater, turn controls to off using light/fan/receptacle switch, and turn power off to

circuit at the main disconnect panel.

• Use this heater only as described in this manual. Any other use not recommended by the

manufacturer may cause fire, electric shock, or injury to persons.

• Do not install on un-insulated exterior walls in cold climate areas.

• Do not install if product is damaged.

• Do not bend, cut, alter, submerge in water, or use for purposes other than described.

• Mirror must be caulked or grouted into tile, flush with the tile surface. Edges of the mirror cannot

be exposed to touch.

• Consult the NEC, Article 551 for rec. vehicle installation.

• SAVE THESE INSTRUCTIONS.

Activate the Shower ClearMirror by a switch. You may decide to connect it to another light or fan

to ensure it is turned off when not in use.

1. Before installing ceramic tile, measure for desired Shower ClearMirror height from the

finished shower floor.

2. Prepare an area for the mirror and adjust for your grout lines.

3. Measure and mark the location of the mirror center.

4. Install junction box per manufacturers instructions. (see Figure 1).