- ページ 7

スピーカー ESI SW10K eXperienceのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。ESI SW10K eXperience 9 ページ。 Professional reference sub-woofer monitor
ESI SW10K eXperience にも：ユーザーマニュアル (13 ページ)

ページを印刷する

ESI

1. XLR inputs – these connectors accept balanced XLR input connections. The XLR input is wired

like this:

2. TRS inputs – these jacks accept TRS input connections, either balanced or unbalanced. For

balanced connections, a 3-conductor TRS plug is necessary. The TRS input is wired like this:

Unbalanced wiring works with either a 2- or 3-conductor TRS connector. A 2-conductor TRS plug

(or sometimes also just called TS plug) automatically grounds the minus signal input, whereas a 3-

conductor TRS plug wired unbalanced provides the option of leaving the minus open or grounded.

We recommend that you ground the unused input.

3. bar code label – this label contains the product serial number bar code.

4. subwoofer crossover control – this controls a 2

limit between 50Hz and 250Hz. You can adjust the crossover frequency for the actual SW10K

eXperience subwoofer output here. If you are not using any satellites connected to SW10K directly,

set this to 250Hz. Don't confuse this with the satellite crossover control (11).

5. volume control knob – use the volume control knob to set the proper input level from the sound

source.

6. power switch – when you push the power switch, SW10K eXperience will be turned on, and

–surprise– it will be turned off when you push the power switch again.

7. power port with ext. fuse – use this connector to plug in the detachable 3-circuit line cord that

connects to the power outlet.

8. phase control – the purpose of this control is to match the phase of the satellite cut off frequency

to the phase of the upper frequency limit of the subwoofer. Adjust the phase control for maximum

sound pressure at cross over frequency in order to make sure that the subwoofer and satellites are in

phase at cross over frequency. This allows you to get the maximum sound pressure and most

accurate sound quality after setup.

9. foot switch connector – this connector allows you to connect a foot switch that you can use to

mute the subwoofer sound. This is helpful if you want to make A/B comparison of the sound with

and without subwoofer and you can quickly control it with a simple pedal.

10. XLR outputs – these connectors provide a balanced XLR signal for left and right channel. If

you are not using an amplifier with its own bass management, you will need to connect your

satellite speakers to these outputs accordingly.

INPUT SIGNAL

Shield

INPUT SIGNAL

Shield

XLR CONNECTIONS

PIN 2

PIN 3

PIN 1

TRS CONNECTIONS

Tip

Ring

Sleeve

order (12dB/octave) low-pass filter with upper

SW10K eXperience