- ページ 7

室内装飾品 ESi Ergo VICTORY 2VT-C48-24 SeriesのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。ESi Ergo VICTORY 2VT-C48-24 Series 8 ページ。 2 leg electric table base

OPERATION

MOVING THE WORK SURFACE TO A SAVED POSITION

Use this function to move the work surface to one of the saved

positions.

• Press and hold the desired memory button, 1, 2 or 3. The work

surface will move to the saved position and then stop.

• Release the memory button. The work surface will move to

the saved position and then stop. The display shows the work

surface height.

CHANGING THE HEIGHT DISPLAY UNITS

This function allows you to change the display units from

centimeters to inches or the other way around.

• Press and hold memory buttons 1 and 2 and the UP s button.

• Release the three buttons after about five seconds. The display

will show S and a number — for example, S5.

• Press UP s until the display reads S5.

• Then press the Setting button S. If the display was set to

centimeters, it will now be set to inches; or vice-versa.

RESET THE CONTROL UNIT TO FACTORY SETTINGS

To reset the control unit to factory settings:

• Press and hold memory buttons 1 and 2 and the UP s button.

• Release the three buttons after about five seconds. The display

will show S and a number — for example, S5.

• Press UP s until the display reads S0.

• Then press the Setting button S. The control unit is now reset to

factory settings.

CAUTION: After resetting the control unit, the "zero setting"

procedure must once again be completed before operating the

table. See Step 12 on page 5.

VICTORY 2 LEG ELECTRIC TABLE BASE

If you release the memory button

before the saved position is reached,

table movement will stop.

If one or more motors are changed

in a system, the control unit must

be reset to factory settings and

the system must be "zero set" as

described earlier.