- ページ 3
会議システム ClearOne CLOCKAUDIO TS-001のPDF テックノートをオンラインで閲覧またはダウンロードできます。ClearOne CLOCKAUDIO TS-001 6 ページ。 Using the clockaudio ts-001 with the converge pro
ページを印刷するFUNCTION
When the touch switch on the ClockAudio TS-001 is pressed, a contact closure is sent to the Converge Pro control pin. The Converge Pro mutes
the microphone channel and sends out a "Mute On" response. With the "Mute On" response, the status pin is pulled to ground and the slave pin
on the relay is grounded energizing the relay. When the relay is energized, the pink wire on the ClockAudio TS-001 is grounded and the red LED's
illuminate.
When the touch switch on the ClockAudio TS-001 is pressed again, a contact closure is sent to the Converge Pro control pin. The Converge Pro
toggles the mute state of the microphone channel, un-muting the channel, sending out a "Mute Off" response. With the "Mute Off" response the first
status pin is un-grounded or set to a high state. The slave pin on the relay is now de-energized. When the relay is de-energized the green wire on
the ClockAudio TS-001 is grounded and the green LED's illuminate.
CONVERGE PRO 88X AND 8I CONTROL/STATUS PROGRAMMING
The Converge Pro Control Status Port A must be programmed to control the muting of the microphone input and illuminate the LED's in the halo.
This programming may be done while connected to the unit or while offline and saved to your site file for future use.
To program Control Status Port A follow the steps below, referencing Image 2:
1.
In the Converge Console, go to the Control Tab section and select Control Port A and select Status Pin 1 from the respective drop-down
list.
2.
Click on the Active (Low) Command button.
3.
In Command Editor, select the appropriate Unit Type and DID then choose command of MUTE, Channel 1 and Group M:
a.
If the touch pad is to act as a toggle switch (press the switch once, the channel mutes, press it again and the channel un-mutes) choose
Mode 2. Advance to step 6 below.
b.
If the touch pad is to act as a push to talk switch (press and hold the switch to unmute, release to mute), choose Mode 0.
c.
If the touch pad is to act as a push to mute switch (press and hold to mute, release to unmute), choose Mode 1.
d.
Click the Apply button located in the lower-right.
Image 2