- ページ 6

薪ストーブ ABC PROIZVOD QUADROのPDF テクニカル・インストラクションをオンラインで閲覧またはダウンロードできます。ABC PROIZVOD QUADRO 10 ページ。

Warning

The stove must be connected to a chimney that meets all national regulations

and standards.

All joints and connections between the stove and the chimney must be well

sealed.

n the range of 200 mm around the ﬂue pipes it is necessary to remove all

ﬂammable or heat-sensitive materials.

During the ﬁrst ﬁring up, a burning of stove paint occurs. We suggest that your

ﬁrst ﬁring up be performed in the open space or in a well ventilated room.

Figure 3 shows the stove radiation zones and the minimum distances from

ﬂammable objects.

3. INSTALLATION

Ensure that the room where the stove is installed has enough fresh air. If

windows and doors are well sealed you could be faced with situation that there is

not enough fresh air needed for good combustion and reliable operation of

thestove. In this case it is necessary to provide fresh air to the rear side of the

stove.

The stove must be connected to the appropriate chimney that must have a

minimum active height of 4.50m. Maximum allowable pressure of primary draft is

20Pa (thrust in the chimney). Diameter of the chimney should correspond the

diameter of the ﬂue pipe on the stove. If the primary draft is big there is a

possibility of a mounting a ﬂap with positioner for regulation of primary draft.

If there is a primary draft regulation ﬂap installed before opening the stove door,

make sure that the positioner on the ﬂap is open as there is a risk of return of

ﬂue gases into the room.

Flap is not part of the ovens' basic equipment but can be ordered from your

dealer or in the factory.

Figure 3