- ページ 6

ネイルガン Altocraft 208-1701のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Altocraft 208-1701 10 ページ。 18 ga.brad nailer with 12-piece starter kit

ページを印刷する

PROBLEM

Air leak at trigger area

Air leak between body and

front plate

Air leak between body and

cylinder cap

Tool driving fasteners too

deeply

Tool runs slowly or has power

loss

Tool skips fasteners

Fasteners jam in tool or in

magazine

Tool will not drive fasteners

down tight

TROUBLESHOOTING

CAUSE

O-ring in trigger valve

damaged or cracked

Trigger valve head damaged

Trigger valve stem, seal, or

O-ring damaged

Piston O-ring or bumper

damaged

Screw loose

Damaged seal

Worn bumper

Air pressure too high

Insufﬁcient lubrication

Insufﬁcient air supply

Broken spring in cylinder cap

Exhaust port in cylinder head

is blocked

Worn bumper or damaged

spring

Dirt in front plate

Inadequate airﬂow to tool

Worn or dry O-ring on piston

Damaged O-ring on trigger

valve

Cylinder cap is leaking

Joint guide is worn

Fasteners in tool are the

wrong size or damaged

Magazine screws or front

plate clamp are loose

Blade in piston assembly is

damaged

Worn blade in piston

assembly

Lack of power

Slow cycling and loss of

power

STOP using the tool immediately if any of the following problems occur. Serious

personal injury could occur. Any repairs or replacements must be done by a

qualiﬁed person or an authorized service centre only.

CAUTION: Disconnect the tool from air supply before performing any service

procedure. When inserting new or re-installing O-rings, make sure they are clean

and lubricated with an O-ring lubricant.

WARNING: Repairs should be made by an authorized repair centre.

Opening this tool could invalidate your warranty.

SOLUTION

Check and replace O-ring

Check and replace trigger valve head

Check and replace trigger valve stem

Check and replace O-ring or bumper

Tighten screws

Check and replace seal

Replace bumper

Adjust air pressure at regulator

Add oil as instructed

Check air supply

Replace spring

Replace damaged internal parts

Replace bumper or pusher spring

Clean drive channel in front plate

Check hose and compressor ﬁttings

Replace or lubricate O-ring

Replace O-ring

Replace seal

Replace joint guide

Use only recommended fasteners

Tighten all

Replace piston assembly

Adjust regulator to adequate pressure

Check cylinder cap spring for broken coils, reduced

length, or if exhaust port is blocked