- ページ 5

ターンテーブル 1 BY ONE H005のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。1 BY ONE H005 14 ページ。 Belt drive turntable system

ページを印刷する

Rotating the Platter

1. Using your hands, slowly rotate

the platter ten times in a clockwise

direction (Figure 1).

2. This step is for resetting the auto

mechanism, getting rid of any twists in

the belt and making sure the belt rides

smoothly along the drive rim on the

underside of the platter.

3. Place the slip mat on top of the platter.

Make sure the 1byone logo on the mat

is facing up (Figure 2).

Cartridge Tracking Force Adjustment

Counterweight is suitable for cartridges weighing between 3.0-6.0g.

The supplied

1. Gently push and turn the Counterweight onto the

rear of the tonearm (with the dial facing towards the

front of the turntable).

2. Pull the protector straight forward to remove it.

Note: Applying a downward force may cause the stylus

to come off the body. Only low volume is output if the

stylus has come off, or is about to come off, so refer to

"Replacing the stylus" to reattach the stylus correctly.

3. Remove the tie-wrap and unlock the tone arm.

4. Lower the tonearm lift and position the cartridge in the space between the tonearm

rest and platter.

Counterweight until the tonearm achieves a neutral, level

5. Carefully rotate the

balance. The tonearm should return to this balanced position if it is moved up or

Figure 1

Figure 2

Slip mat

Counterweight

Tracking Force Dial

down. Perform this adjustment carefully.

Adjust so the tonearm is level

6. Once the tonearm is correctly balanced, return the tonearm to its rest. Without

moving the metal counterweight, gently rotate the tracking force dial to align

the "0" with the black center line. Check to make sure the tonearm is still neutrally

balanced.

Counterweight

Tracking Force Dial

Center Line

7. Finally, hold the rear of the counterweight and rotate it counterclockwise(as seen

from the front) to adjust the tracking force according to the cartridge manufacturer's

recommended 3.5g.

Note: Take care and do not touch the tracking force dial during adjusting the

tracking force.

Note: Each mark on the dial represents 0.05g. The recommended tracking force for

the factory-installed cartridge is 3.5g±0.5g. It only goes up to 2g for one rotation of

the tracking force dial, meaning you will need to make the second rotation and

stop at "1.5" to reach 3.5g.

Counterweight

Tonearm

1.5