- ページ 10

電話 ClearSounds CSC600ERのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。ClearSounds CSC600ER 17 ページ。 Clearsounds telephone user manual
ClearSounds CSC600ER にも：特徴 (1 ページ)

ページを印刷する

BASIC FUNCTION

1. Redial function

This feature allows you to redial the last number you have called by

one-touch operation.

a. Lift handset or press the

SPEAKER

b. Press the

REDIAL

button to redial the last number called.

2. Flash function

Press the

CALL WAITING

button to terminate a call and institute a

dialling tone for another call or to get another call from "Call Waiting"

(a special telephone service).

NOTE:

If you do not have any special telephone service, such as Call

Waiting, press the

CALL WAITING

your current conversation.

3. Speaker function

To switch your call to speakerphone, press the

replace the handset in the cradle. To switch back, simply pick up the

handset. In the speaker state, you can make or answer a call.

4. Speaker volume adjustment

To adjust the speaker volume, move the

the right side of the unit to the desired position.

5. Receiver volume and tone select switch

You can adjust the receiver volume by sliding the

Also you can amplify the receiver volume and tone frequency

according to your own hearing requirements.

Amplify Feature part of the manual for details.

NOTE:

The unit must be connected to adapter for the receiver volume

and tone adjustment.

button to get a dial tone.

button during a call may disconnect

SPEAKER

button and

VOLUME

switch located on

VOLUME

control.

Please see the

B. To take attention to everything happens at home by remote

control whenever

To have the function, you need to turn on the "Auto turn on " and

remember the Pin code.

1. To turn on " Auto turn on "

When the LCD shows the

SET SOS

confirm. Then select the

Auto turn on

button to enter. The LCD shows

the "Auto turn on " function.

2. To set Pin code

When the LCD shows the

SET SOS

confirm. Then select the

Pin code

to enter. Enter the Pin code (up to 4 digits, and the default Pin code is

1234), then press

DIAL

button to confirm.

After turn on " Auto turn on " and set the Pin code, you can use the

function as follows.

After 10 times ringing is detected, the phone will be auto off-hook

the line (In this state, the user can hear the caller but cannot answer

the caller), and then generates two "bip-bip" tones to remind the

caller to enter Pin code to enter full speaker state. The caller enters

the Pin code, and then starts the conversation. Every about 2 minutes

later, the caller will hear two "bip-bip" tones. Press special buttons

(0 9,*,#) to continue the conversation. Otherwise, the line will be

disconnect automatically.

NOTE:

When the phone is auto off-hook the line, the receiver can

press the

SPEAKER

button to enter full speaker state with caller. In

this way, there is no need for caller to enter Pin code.

menu, press the

DIAL

button to

menu and press the

DIAL

ON/OFF

. Then select

to turn on

menu, press the

DIAL

button to

menu and press the

DIAL

button