ページを印刷するOperation:
Input switch:
You can change the source input from the front panel, also from the Remote Control Unit.
Input changing is sequential, in one direction from the font panel, and bidirectional from
the Remote Control Unit. The last input is remembered and restored after next power up or
wake up from standby.
The sequence can be changed by user. Also the input you never used can be avoided.
Digital Filter switch:
This feature allow the user to choose between various types of the digital filters (sharp/slow
roll-off, long/short delay, etc.) according to his/her sound preferences.
ATDAC-10S remember the digital filter mode separately for each PCM/DSD sample rate.
It is not recommended to use DF>4 for 44/48kHz because of a high frequency degradation.
Volume control:
Basic version has only digital volume control. We do not recommend to use it, because of a
sound quality degradation, but sometimes it is useful. Digital volume control not influence
to the auxiliary analogue input.
If you not use it, keep it at maximum value (0dB).
If your device is equipped with the analogue volume control (option), you can use it for all
inputs.
You can change the volume from the Remote Control Unit only. The last volume setting is
remembered and restored after next power up or wake up from standby.
Using auxiliary analogue input:
Auxiliary analogue input is intended for using with different analogue sources, like
turntable phono stage or cellular phone. Remember that digital volume control does not
work in this mode!
Standby:
If auxiliary analogue input is active, device enter standby mode after a long time (24h by
default).
With USB/SPDIF/TOSLINK inputs, device enter standby mode (after 2min by default) if
there is no valid signal presents and wake up immediately when the signal become valid.
Due to a low device' power consumption it is not mandatory to switch the power of by the
main switch at the back panel. Use can use it just for a long period of non using.
©2018.
®Altor Co
Altor
A U D I O
Netanya, Israel