- ページ 6

産業機器 Dixon Bayco DBC SeriesのPDF メンテナンスと取扱説明書をオンラインで閲覧またはダウンロードできます。Dixon Bayco DBC Series 13 ページ。 3" dry disconnects

Reassembly

Prior to reassembly, inspect all components for damage especially

scratches to the sealing surfaces. Pay close attention to the BODY,

POPPET, SEAL CYLINDER, STUFFING BOX, and main SHAFT. If

you are re-using any seals, inspect them to make sure there are no

cracks or locations showing wear. When in doubt, it is often better to

replace a seal at this stage rather than tear the unit down again.

All lubricants used in the assembly of Dry Disconnects

must be compatible with the seal material used and also with the

commodity being transferred through these fittings.

1. Assemble two CAM ARMS to the BODY using two pins. Position

the CAM ARMS between the ears in the BODY and hammer two pins

through the holes in the BODY ears and CAM ARMS.

2. Press the flanged BEARING into the STUFFING BOX with the

BEARING flange located away from the STUFFING BOX hex end.

Use red Loctite #277 on the BEARING prior to pressing into place.

Take care not to get the Loctite on the inside of the BEARING.

3. Install the O-RING over the STUFFING BOX threads and seat

against the hex shoulder.

4. Lubricate the STUFFING BOX O-RING and insert into the

STUFFING BOX.

5. Place the spring seat WASHER through the coupler end of the

body. Two large tabs on WASHER fit into slots in the BODY and

point toward the threaded end.

6. Insert the SEAL CYLINDER O-RING into the groove in the BODY.

Apply a liberal coating of grease to the O-RING and to the bore of the

BODY where the SEAL CYLINDER will be placed.

- If the unit uses a PTFE O-RING, take care not to crease the

O-RING when inserting it into the BODY groove. The O-

RING should be lubricated and inserted into the BODY bore

such that the O-RING goes past the groove. Then the O-Ring

is pulled back up into the groove and worked around until it is

in the groove.

7. Insert the SPRING into the BODY centering it over the 4 tabs on

the spring seat WASHER.

DBC 3" Series Dry Disconnects

877.582.3569

DBC 3" SERIES