- ページ 8
アクセサリー Acoustical Systems AXIOMのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Acoustical Systems AXIOM 16 ページ。
ページを印刷する
- 1. Table of Contents
- 2. Technical Features & General Design
- 3. Alignments
- 4. Unpacking the AXIOM
- 5. Mounting the AXIOM
- 6. Setting up the AXIOM
- 7. Balancing the AXIOM
- 8. Antiskating
- 9. Setting Vertical Tracking Force
- 10. Setting Horizontal Operation Point
- 11. Aligning the AXIOM
- 12. The Genuine Alignment Template
Mounting the AXIOM
The AXIOM is mounted with (1) M5 screw
and (1) hardened stainless steel washer only.
In the accessory box you find (1) 4.2 mm drill
and (1) M5 tap and die. With these tools you
do create the single M5 thread needed to mount
the AXIOM on your turntable.
IMPORTANT
The M5 thread (or 5 mm diameter
hole if the material of the turntable's
armboard does not allow for a thread
- for instance: wood) has to have the
following distance from the center of
the turntable's spindle:
u AXIOM with fixed mounting head: 233 mm
u AXIOM with SME-bayonet head: 266 mm
Please use a M 4.2 mm drill and a M5 tap
and die to create the M5 thread in the desired
distance from the center of the spindle.
Now do take the AXIOM and hold it in place
vaguely at the spot above the M5 thread.
Please check approximately how much the
AXIOM has to be elevated so that it's arm
wand is horizontal level and 6-8 mm above the
turntable platter.
Now do take the (3) hardened stainless steel
washers. Select the one most likely to elevate
the AXIOM to a suitable horizontal position
relative to the turntable platter's surface.
The AXIOM's arm wand's underside shall be
approximately 1/3" or 8 mm above the surface
of the platter.
If in doubt, start with the 8 mm washer first.
This should bring the AXIOM to the needed
horizontal level on most turntables.
Now take the stainless steel washer and look
at it.
The top side is flat.
It's underside has a distinctive - if only 2/10
mm high - rim at the edge. Do put the washer in
the indention underneath the mounting area on
the AXIOM.
Do take the (1) 30 mm length M5 screw.
Put it through the suitable center hole on the
AXIOM's mounting area and through the
center hole in the stainless steel washer sitting
underneath.
Make sure the (1) short fist screw driver 8.0 x
25 is within your reach.
Do put the whole AXIOM assembly right on
top of the M5 thread and secure in place by
screwing down the M5 screw.
8