- ページ 17
温室キット ClearSpan 104903のPDF 組立説明書をオンラインで閲覧またはダウンロードできます。ClearSpan 104903 19 ページ。 Premium solar star greenhouse
ページを印刷するREMEMBER: Flashing is installed under the
polycarbonate of the roof and side panels and it
overlaps the polycarbonate of the end panels.
4. Continue to install the flashing until one end is
complete.
5. Repeat the steps until all flashing is installed.
6. Continue with the final check of the greenhouse.
FINAL CHECK OF ASSEMBLED GREENHOUSE
1. After all flashing is installed, inspect the assembled
greenhouse and verify that all brackets are in place
and secure.
2. Inspect all corner brackets to verify that all panel are
secured to these brackets.
3. Remove any sharp corners or edges that are
present to prevent injury.
4. Align the plastic lumber base (if needed) with the
metal frame base and secure the plastic lumber to
the frame base using the A-Angle brackets as
shown.
5. Read the MUST READ document and the anchoring
information for the greenhouse.
Visit www.ClearSpan.com for additional products and customer assistance.
Door (and
Non-Door)
End Panel
ANCHOR THE GREENHOUSE
Strong winds will cause the greenhouse to shift. It must
be anchored to the site.
The site on which the greenhouse was constructed will
determine the required anchoring method. Consult a
professional contractor to determine the best and safest
way to anchor the greenhouse.
WARNING: To prevent property damage and serious
personal injury, the assembled greenhouse must be
anchored to the site. READ THE MUST READ
DOCUMENT.
ANCHORING EXAMPLES
The diagrams below illustrate two possible ways to
properly anchor the shelter to the site.
The parts shown in the diagrams below are not included
with the shelter and must be purchased separately.
Contact Customer Service at 1-800-245-9881 to
purchase additional parts to anchor the shelter.
ANCHORING SUGGESTIONS
Anchoring System
when on concrete
Ground Anchoring
System
ATTENTION: After anchoring the greenhouse, read the
Care and Maintenance information that follows.
16 of 18