ページを印刷するCLEARSPAN
END FRAME KIT
™
3
ASSEMBLE AND ATTACH FRAME BRACES
Gather the parts:
•
Frame braces (#EG12W1202)
•
Square head screws (#FAS8)
•
1.315" Fabric clips (#CC6212)
•
90° Connectors (#104637)
•
Phillips head screws (#FAF25P)
•
Tek screws (#FA4482)
View the diagrams to assemble and attach the two (2)
frame braces.
1. Gather the two (2) frame braces and the two (2) CC6212 fabric clips. Attach each fabric clip to the end of a frame
brace using a FAS8 square head screw. Center the clip on the brace end as shown below.
2. Set assembled frame braces into position by seating the plain end against the door jambs and clipping the fabric
clip to the ground post. Verify the braces are straight and level. (Push fabric clips into the ground if needed.)
3. Once in position, secure fabric clips by installing a Tek screw through the clip and into the ground post from the
inside of the shelter. Drill a hole through the fabric clip if needed.
4. Secure the brace to the door jamb from the inside of the shelter by attaching a 90° connector using FAF25P
Phillips head screws. Position connector so it does not contact the anchor stake.
Step 1
FAS8
CC6212
EG12W1202
Step 4
FAF25P
8
Step 3
FA4482B
104637
Step 1 & 3
EG12W1202
Ground Level
Drawing may show a different but similar model.
Ground Post
EG12W1202
Step 4
Ground Level
Inside View
EG12W1202
Views are seen from the
inside of the shelter.
EG12W1202
Step 4
Step 1 & 3
Revision date: 05.18.10