- ページ 12

温室キット ClearSpan 108986のPDF マニュアルをオンラインで閲覧またはダウンロードできます。ClearSpan 108986 17 ページ。 End frame kit 36' wide x 16' 2" high

CLEARSPAN

END WALL FRAMING KITS

™

INSTALL THE END RATCHETS FOR THE MAIN COVER

After end panel is fully stretched and all doors are installed

(if equipped), reattach end ratchets for main cover bonnet.

May not apply to some shelters and end panels.

Gather the parts:

•

Ratchets

•

Tek screws (#FA4482B)

Complete these steps to reattach ratchets to base rail (if

present). Attach ratchets to building end rafter or concrete

slab if base rail is not present.

1. Pull bonnet portion of main cover back over end rafter.

2. Locate the four ratchets and attach each ratchet to the

outside of the end frame base rail (if equipped) using a

Tek screw (FA4482B). Use the cover strap to position

the ratchet.

Frame shown may differ

from the actual frame.

3. Locate straps at the front and rear of main cover and

feed straps through center slot in each end ratchet.

Diagram shows the

ratchet attached to the

end wall base rail. This

ratchet is used to secure

the bonnet portion of the

main cover.

4. Tighten end ratchets to secure bonnet portion of the

main cover.

5. Move to the other end of the building and secure main

cover bonnet at that end.

6. After securing the main cover bonnet, read the care

and maintenance information section.

Main Cover

Bonnet

End

Panel

Revision date: 11.12.14