- ページ 10

パワードライバー Dixon Automatic Tool SKC-PTA-B35FのPDF 操作およびメンテナンスマニュアルをオンラインで閲覧またはダウンロードできます。Dixon Automatic Tool SKC-PTA-B35F 12 ページ。 Automatic industrial cordless brushless power torque screwdrivers series

ページを印刷する

5. Chemicals, Acetone, Benzene, Alcohol, Thinner, Ketone, trichloroethylene, etc shall not be in contact

with the surface of the screwdriver in order to prevent chemical damage.

6. Please follow instruction carefully and do not drop or shock the screwdriver.

7. This is an external torque adjustment screwdriver, 0 on the torque adjust ring stands for minimum

torque and 8 for maximum torque. The rated operation time is 1 second / 3 seconds (ON / OFF).

Appropriate fastening frequency is 15 fasteners in each minute. Overrunning may damage motor due

to overheat. Proper amount of screwdriver resting is recommended to prevent motor overheating.

8. Not allow to turn the Hi/Lo switch during operation in order to cause system malt-function.

9. The device will not be able to function again once the OK/NG indicator/signal is not turn off yet.

10. When adjusting the torque, for safety purpose should stop the screwdriver completely and set the

switch to neutral position. It could prevent the user from turning the tool on accidentally.

11. During operation, the switch has been changed accidentally that the device will enable its self-

protecting mode which is power off. Re-start the tool when this happen.

12. Each operational torque setting, using time and frequency may result in different level of wear and

tear, at higher torque setting and use extensively could accelerate the wearing down of tool. After one

month, the torque is getting reduce gradually at the rate of 2~3% or 3~5 %( max torque). The longer

use of the device, torque reduction will become stable and the users could measure the torque by a

tester on a regular time schedule to check if the torque power still meets the criteria.

13. SKC-PTA-B60/35/35F are tested by our torque meter KTM-CSH.

14. Kilews cordless screwdriver torque output is generated by clutch machnisam, and it is applicable to

ISO 6789.

Description of Battery and Charger

1. KILEWS SKC-LB1820B series of batteries as options to fit in the device; you may consult with local

agent based on your task requirement.

2. The use of other than genuine KILEWS batteries or screwdrivers can't be active due to the build-in

protection system enforce no charging.

3. Recommended to use SKC-P80W-D