- ページ 13

建設機械 Altrad BELLE TDX 650AのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Altrad BELLE TDX 650A 18 ページ。

Having carried out the checks listed in the 'pre start' section, you may start the engine.

The ALTRAD Belle TDX 650A Roller is tted with a centrifugal clutch; this allows the engine to run at idle without driving the

Hydraulic pump.

As the engine speed is increased the clutch will engage and the engine will drive the Hydraulic Pump to send the hydraulic

power to drive the drums, and to drive the vibration mechanism as well. To avoid any damage to the centrifugal clutch, move

the throttle lever quickly from L to H position. For correct operation, the engine speed should be set to maximum during the

compaction operation

Avoid operating the machine on a fully compacted, hard, or non-yielding surface. Otherwise, the bearings and other mechanical

components will be damaged, and the life of the machine will be greatly reduced.

When working on a steep slope, pay extra care in operating the machine so that the machine roll down the slope.

Always work up or down the slop. Do not work across the slope. If the machine is parked on a slope, always apply the Parking

Brake Lever.

When the machine is going in reverse, make sure not to stand behind the Operation Handle. Always walk along the Operation

Handle and face toward the direction of travel.

Lifting

Where it is necessary to use lifting equipment to position the TDX 650A, make sure the lifting equipment has a WLL (Working Load

Limit) suitable for the machine's weight (see Tecnical Data table). Attach suitable chains or slings ONLY to the lifting points provided

at the centre of the machine (Lifting Eye) or at each corner of the machine (Strapping Points).

TRANSPORTATION

Transportation on a vehicle.

Make sure to lock the Handle and use proper slopes of suf cient width, length, and strength on loading to and unloading from

the vehicle.

Apply the parking brake, and tie the machine rmly to the vehicle during the transportation.

Maintenance

The ALTRAD Belle TDX 650A is designed to give many years of trouble free operation. It is, however, important that the simple

regular maintenance listed in this section is carried out. It is recommended that an approved ALTRAD Belle dealer carries out all major

maintenance and repairs. Always use genuine ALTRAD Belle replacement parts, the use of spurious parts may void your warranty.

Before any maintenance is carried out on the machine, switch off the engine and remove Key from the Key Switch

Always set the machine on level ground to ensure any uid levels will be correctly read. Only use recommended oils (see page 15).

Servicing the Engine

Service the engine according to the engine manufacturer's speci cations.

Refer to the engine operation and maintenance manual.

Note: When the Maintenance Cover has been removed, ensure that all Bolts are securely fastened when re- tting. DO NOT restart the

machine with guards removed.

Maintenance: Every 8 hours or daily

Check for loose bolts and nuts, retighten if necessary.

Check and clean the air lter element, re-lube the element in accordance with the engine manufacturer's recommendations. If

operating conditions are unusually dusty and severe, lter element cleaning should be done more frequently.

Check Engine Oil Level before operation.

Maintenance: After rst 50 hours and every 200 hours thereafter

Change the Engine Oil - see procedure on page 15.

Operating the TDX 650A Roller

Servicing