- ページ 7
温室キット ClearSpan R024B00003のPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。ClearSpan R024B00003 7 ページ。 End panel
ページを印刷するCare and Maintenance Information
HORIZONTAL CONDUIT INSTALL (continued)
4.
Once the ratchets are attached, make a horizontal slit
(approximately 3"– 4" long) in the horizontal pocket
containing the conduit directly above each ratchet.
See the circles in the photo below.
Cut only the end panel pocket. DO NOT cut through
the end panel.
5.
Locate the 1" strapping and cut a section that reaches
from the ratchet (#QH1061), around the horizontal
conduit in the end panel pocket, and back to the
ratchet.
NOTE: Allow enough extra strap so you can insert
both ends of the strap into the ratchet.
6.
Thread one end of the strap in through the slit, around
the conduit, and back to the ratchet.
7.
Align the strap ends and insert both ends into the slot
in the center hub of the ratchet.
8.
Tighten slightly and repeat the steps for the remaining
straps and ratchets.
ATTENTION: If the strap "builds up" inside the
ratchet, loosen the ratchet, remove the excess strap,
and retighten.
9.
Return to all horizontal conduit ratchets and tighten.
10.
Continue by reading the care and maintenance
section that follows.
Revision date: 06.21.12
End
Panel
Conduit
Inside View
CARE AND MAINTENANCE
Proper care and maintenance of your ClearSpan™
end panel and its components is important. Check the
following items periodically to properly and adequately
maintain your building and panel:
•
Regularly check the main cover and panels to see that
these remain tight and in proper repair.
•
Check all fasteners frequently to verify that these
remain tight and in good repair.
•
Do not climb or stand on the building or frame at
anytime.
•
Remove debris and objects that may accumulate on
the shelter. Use tools that will not damage the cover or
end panel when removing debris.
•
Remove snow to prevent excess accumulation. Use
tools that will not damage the cover when removing
snow. Never allow snow to accumulate on the main
cover or to remain against the sides or end panels
after it is removed from the main cover.
•
Check the contents of the shelter to verify that
nothing is touching the cover or end panels that could
cause damage.
•
Replace all worn or damaged parts immediately.
•
For replacement or missing parts, call your sales
associate for assistance.
7