- ページ 6
温室キット ClearSpan R024B00008のPDF マニュアルをオンラインで閲覧またはダウンロードできます。ClearSpan R024B00008 13 ページ。 Twin-wall polycarbonate end panel kit 20' wide & 24' wide
ページを印刷するEND PANEL INSTALLATION (continued)
4.
Locate and mark the center of the end wall and set
the first prepared panel, with the UV-protected side
facing to the outside, in position. Align the center of the
H-channel with the center of the end frame.
ATTENTION (Upper Panel Installation): For a 20'
wide greenhouse frame, trace the 108867 end cap
profile location on the panel, remove the panel, and cut
to fit. For other 20' wide building frames, cut panel to
length using the end rafter as a guide.
5.
Verify that the panel is square on the frame in the
desired position with the UV-protected surface toward
the outside. Attach it to the end frame using Tek screws
and washers (see photo to the right). Install the Tek
screws through the panel and into the brace every
12" on-center. Do not overtighten screws! For Tek
screws in the channel of the aluminum H-channel, do
not use washers.
6.
With the panel attached to the end frame, repeat the
steps to install the next panel. See diagrams on this
page.
For the 20' wide frame, install all remaining panels
and continue with Step 16. For the 24' wide frame,
continue with Step 7.
Diagram below shows the 24' wide end wall.
Actual end frame and panels may differ from frame
shown. The installation of doors also will affect
panel installation and position. Consult the panel
diagrams located in the Quick Start section for the
end kit ordered. ATTENTION: Installation of doors
and other accessories in the end wall may result in
leftover panel material and fasteners.
24' Wide End Wall
6
End Panel Installation
Trace & trim
panels,
then tape
the top edge
with vent
tape.
20' Wide End Wall
Trim H-channel as
needed to fit under
the lip of the end
cap. The 108867
end cap is included
with the greenhouse
frame only.
4' x 8'
4' x 8'
Panel
Panel
A
4' x 8'
4' x 8'
Panel
Panel
GROUND LEVEL
A
Tek screws
Tek screw
and washers
Use assistants when setting and securing the
panels to the end frame.
6' x 12'
Panel
104212
H-Channel
Ground Level
End Cap
108867
Rafter
After trimming end panel to length, tape
the top edge and slide panel under the lip
of the end cap before securing to frame—
greenhouse frames only.
Brace
Brace
only
6' x 12'
Panel
Tape
Revision date: 08.22.13