- ページ 5

インバーター AIMS PWRINV150WのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。AIMS PWRINV150W 7 ページ。 150 watt

ページを印刷する

• Under Voltage Protection. The RED LED Indicator Light will illuminate and

the inverter will automatically turn itself off when the input is less than 10.0

+/- 0.5 volts DC.

• Overload Protection. The RED LED Indicator Light will illuminate and the

inverter will automatically turn itself off when the continuous draw of the

equipment being operated exceeds 400 watts or the surge draw of the

equipment exceeds 800 watts.

• Thermal Protection. The RED LED Indicator Light will illuminate and the

inverter will automatically turn itself off when the circuit temperature

exceeds 150° F .

Notes

• The inverter is equipped with a cooling fan, which is designed to run

automatically when the inverter begins to get hot. Automatic shut down of

the unit caused

by high circuit temperatures will occur when the cooling fan is

unable to

maintain a cool enough temperature for safe operation.

• In the event of automatic shut down or a continuous audible alarm, turn the

inverter power switch to the OFF(O) position until the source of the problem

has been determined and resolved.

Television and Audio Suggestions

Although all AIMS Power inverters are shielded and filtered to minimize signal

interference, some interference with your television picture may be unavoid-

able, especially with weak signals. However, here are some

suggestions that may improve reception:

• Make sure the television antenna produces a clear signal under normal

operating conditions (at home plugged into a standard 110-volt AC outlet).

Also, ensure that the antenna cable is properly shielded and/or good quality.

• Change the positions of the inverter, antenna cables and the television power

cord.

• Isolate the television, its power cord and antenna cables from the 12-volt

power source by running an extension cord from the inverter to the television

set.

• Coil the television power cord and the input cables running from the 12-volt

power source to the inverter.

• Attach an AC interference filter or similar product between the inverter and the

television power cord. These filters are available at most electronic supply

stores.

AIMS Power Inverter 150W

Note: Inexpensive sound systems may emit a "buzzing" sound when

operated with an inverter. This is due to the inadequate filters in the sound

system. There is no solution to this problem other than purchasing a sound

system with a higher quality power supply.

In Review

• Never attempt to operate the inverter from any other power source other than

a 12-volt battery.

• The inverter is designed to be connected to the power source with the supplied

12-volt power cord or the battery clips. Do not attempt to modify the cords or

battery clips in any way.

• When connecting and using the inverter, make sure that the inverter is posi-

tioned far away from any potential source of flammable fumes or gases.

• Make certain that the power consumption of the equipment you wish to

operate is compatible with the capacity of the inverter. Do not exceed

400-watts.

• When attempting to operate battery chargers, monitor the temperature of the

battery charger for approximately 10 minutes. If the battery charger becomes

abnormally warm, disconnect it from the inverter immediately.

• Use only 40 amp spade type fuses for the inverter.

• When operating the inverter with an automobile or marine battery, start the

engine every 30 to 60 minutes and let it run for approximately 10 minutes to

recharge the battery.

• In the event of a continuous audible alarm or an automatic shut down of the

unit, turn the inverter OFF immediately. Do not turn the inverter ON again

until the source of the problem has been identified and corrected.

• To avoid battery drain, always disconnect the inverter when not in use.

• Do not expose the inverter to rain or moisture.

• Avoid placing the inverter near sources of heat

• While in use, make sure that the inverter is properly ventilated.

• For best operating results, make sure the unit is placed on a flat surface.

• When operating an appliance at 180 watts and above, use the supplied battery

clips for direct connection to the 12-volt power source.

Owner's Manual

of in direct sunlight.