- ページ 3

セキュリティシステム DIY BT-104GSMのPDF インストールとユーザーマニュアルをオンラインで閲覧またはダウンロードできます。DIY BT-104GSM 8 ページ。 Business/home gsm alarm systems

⒈ 10-pin ports : GND; SIREN; RELAY1; RELAY2; SPEAKER;

The first port is educed end of ground,

The second port is educed end of siren, connect sourced siren directly, the other end of siren

connect GND;

The third and fourth port is the educed end of relay, it is normally open and will keep close for three

minutes (this function can be closed)when alarming, it can link the power and video when working;

The fifth port is output of intercom that can connect the speaker, the other end of speaker connects

the GND,

The sixth, seventh, eighth, ninth and tenth port are wired input, every port shorted or disconnected

to GND will trigger alarm.

⒉ SIM card slot: Turn over the host to the bottom, take out the SIM card slot, put the GSM in it and

insert it back.

⒊ Record key : press the RECORD for 2 seconds to enter record status.

⒋ Reset key : Press the RESET key on the back of the host and then plug in power. Then the signal

light flashes once or the siren sounds a "di", means the alarm system has been reset. After reset, all

settings come back to original status, all of the detectors information will be deleted , the original

password is 123456, it does not affect the SMS control and other functions while resetting.

⒌ Power slot: Connect 12V/1.2A DC, the core is positive pole, the crust is negative pole.

⒍ Built-in battery switch ON : Connect to Built-in battery when the switch turn to "ON", at this time the

external power will recharge the battery automatically.

⒎ Antenna: You should connect antenna before insert the power supply.

How to power on

Turn over the host to the bottom, take out the SIM card slot, insert SIM card , then insert DC

power(12V/1.2A) into the host or open the power switch of internal battery, the light POWER becomes

red, the light STATUS becomes red then becomes orange flashing slowly, the host starts to search the

GSM network and check the status of SIM.

If the checking is successful and finding the stored phone numbers, the light becomes green flashing

slowly means the host has been armed.

If there is no phone number, the light becomes green, means the host is disarmed.

If the light becomes red flashing slowly, means the host is in alarming status,

if the light becomes red flashing fast, means the host is in the remote controlling of in-coming

phone/SMS. In normal status the third light RECORD is off, but becomes red when recording .

If the fourth light SIGNAL becomes flashing ,means the host has been connected to the GSM

network, and can be used.

How to set alarm phone numbers

Under normal arming/disarming status, users can send a SMS to set the phone numbers , the format is :

password#operating code# .

Sending a SMS: 123456#10#13905950000#，represents storing NO.1 number to receive SMS.

Sending a SMS: 123456#11#13905950001#，represents storing NO.2 number to receive SMS.

Sending a SMS: 123456#12#13905950002#，represents storing NO.3 number to receive SMS.

Sending a SMS: 123456#13#13905950003#，represents storing NO.4 number to receive SMS.

)

;