- ページ 2
おもちゃ DIY handmade goods-COFFEE TIMEのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。DIY handmade goods-COFFEE TIME 12 ページ。
ページを印刷する
Making tips
LED
wire
1. LED wiring indication:
White=Positive;Grey=Negative.
2.Use a craft blade to carefully
skim over the plastic to bare the
copper wire.
3. For LED wiring extension,
please refer to the below steps:
LED
wire
Do the same on the
Twist the copper of
white wire.
both LED wire and
Remarks: Tie a knot
extension wire
at the end of the grey
wire to differentiate
together.
the polarity.
Place another wire
Roll and wrap the
next to it.
wire.
Remarks: DO NOT
contact both copper
wire to avoid short
circuit.
Warnings
The product is not suitable for children
under 14 years old. The should be under
custody of adults when playing with the
product.
There are small parts, please do not swallow
them for avoiding dangerous accidents.
Tips for assembling
1.Picures shown on the package may
be slightly different from the actual
product.
LED
Extension
2.Please use the provided tracing
wire
wire
paper for cutting purpose to achieve
the best
outcome.
3.Product designs and specification
may be subject to change without
Place the duly twist
advance notice for purpose of making
wire on the tapes
improvement.
4.Testing on LED function:
provided.
Roll and wrap it together.
How to assemble the battery holder
1.Material and tools needed:
- Battery holder, LED bulb,
tape.
3.Wrap the exposed wire
with the tapes.
DO NOT contact the
LED wire end direct
to the battery cell.
5.Set the black key on the
battery box to one side
Use the provide battery
of "ON" as shown.
holder. Make sue the
correct polarity.
2.Twist the following wire together:
(I) WHITE wire from the battery box
with the GREY wire from LED bulb.
(II) GREY wire from the battery box with
the WHITE wire from LED bulb.
Rubber paper
4.Tear off the rubber paper
6.Ture on the power and
complete the installation.