- ページ 4
コントローラー diybook KG Garden Gate Closer GTS 120のPDF 取り付けをオンラインで閲覧またはダウンロードできます。diybook KG Garden Gate Closer GTS 120 9 ページ。 Garden door-closer
diybook KG Garden Gate Closer GTS 120 にも： 取付方法 (7 ページ), 組立説明書 (7 ページ)
ページを印刷する
gardengatecloser.com
a diybook KG brand
Note: In step 3 the exact positioning of the bracket will be checked again and possibly fine-tuned.
Step 3: Check piston stroke
This step is to check the measured position of bracket 1 and possibly change it slightly, so that the optimized closing
performance can be guaranteed. If you choose to proceed with the measurements done before you can skip this step.
However, we strongly advise you to take your time for this verification.
To verify the mounting positions fix bracket 1 provisionally at the position as measured before and install the gate
closer in the mounting hole as chosen before. Close the gate and mark the position of the bolt on the frame of the gate
(mark 1). Then open the gate and mark again the position of the bolt on the frame (mark 2).
If the distance between the two marks amounts to about 155 mm, the position of the bracket is optimal. If the
distance is a bit less, increase distance B a bit. If the distance is bigger than 155 mm, decrease distance B or choose
another mounting hole.
Note: The gate closer can be installed in any mounting hole of the bracket, as long as the distance is correct. If you use a
larger bracket than 60 mm (80 or 100 mm) we advise you to choose one of the centred mounting holes so you can
possibly fine-tune the gate closer later.
diybook KG
Korneuburger Strasse 68-70/2
AT-2102 Bisamberg, AUSTRIA
UID-Nr: ATU67654415, DE313733795
FB-Nr: FN 387443 w
telephone: +43 2262 712 51
fax: +43 2262 712 51-77
email: [email protected]
website: https://gardengatecloser.com
page 4