- ページ 16

3Dプリンター DIYElectronics PRUSA I3のPDF ビルドマニュアルをオンラインで閲覧またはダウンロードできます。DIYElectronics PRUSA I3 19 ページ。

Materials needed: Door Knob

Printed door kno

M4 x 16 screw

[8.1] Door Hinges

• Assemble the two parts

of the printed hinges using

M5x50 scews and nuts

* Don't tighten these too much as it will

be diffiuclt to freely open the door

• Attach hinge to perspex

with M4x12 screws M4 nuts

and washers

• Attach the door to the enclosure

at hinges with M4x16 screws

* Before tightening these screws, make sure the

doors line up and do not catch on the enclosure.

Once the door is correctl aligned, you may tighten

the screws

M4 nut

M4 washers