- ページ 8
スパ・アクセサリー Clearwater Spas CLEAR A-400のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Clearwater Spas CLEAR A-400 20 ページ。
ページを印刷するItems included with CLEAR:
•
Copper testing Kit
•
Four-in-one Test strips (alkaline, pH, calcium and chlorine)
•
Bacteria test kit
•
Bottle of Alkaline Up, pH Up, and pH Down
•
Spa chlorine granulars
FIRST VISIT (1st Day):
1. Fill your hot tub with water to the appropriate level (check your spa
manual for reference).
2. Test the alkalinity, pH, and calcium levels using the test strips
provided. Adjust the water if necessary using the provided products.
3. If the TA (total alkalinity) and pH both need adjusting, correct the TA
first. Reference the test strip to determine the levels. Plan to adjust
the pH at the next visit. Your water should read as follows:
pH: 7.2-7.6
TA: 80-120 ppm
CH: 150-300 ppm
4. Setting the copper level: Set the 'Ion/Action' and 'Large Dose'
values according to the operating manual. Set the'Ion/Action' first,
then set the 'Large Dose'. When the 'Large Dose' expires, test the
water with the copper test kitprovided. The recommended range is
0.2-0.4 ppm. If the ion level is below 0.2ppm, run the 'Large Dose'
functionagain and repeat until the range of 0.2-0.4ppm is reached.
5. Bacteria Test: Once the copper has reached optimum level, you may
test water for bacteria by following the directionson the bacteria
test kit provided. Use the bacteria test strips and repeat as needed.
IMPORTANT! CLEAR IS DESIGNED TO WORK IN CONJUCTION
WITH LOW LEVELS OF CHLORINE. A minimum of0.5 to 1 ppm is
recommended by the EPA. Check the sanitization levels regularly.
IMPORTANT! Do not use bromineor chlorine tablets.
If your spa tests positive for bacteria, immediately super-chlorinate
your spa using spa chlorine only and do not usefor 8 hours.
8 | User Guide