- ページ 9

フロアマシン Edic ENDEAVORのPDF オーナーズ／オペレーターズ・マニュアルをオンラインで閲覧またはダウンロードできます。Edic ENDEAVOR 17 ページ。 Multi-purpose extractor
Edic ENDEAVOR にも：クイックマニュアル (15 ページ)

RECOVERY TANK FILTERS:

VACUUM PRE-FILTER:

The intake filter bag has been designed to catch larger

debris before it enters the open area of the waste tank.

This keeps the auto-dump intake filter from clogging

too fast, allowing un-interrupted flow to the auto-dump

pump.

Locate the filter bag in the waste tank, press the cord

release (circled above in white) and pull back to loosen

the drawstrings. Remove all solids, rinse the bag out and

place back into the tank. Tighten the cord release. Al-

ways remove the bag by loosening the cord, do not pull

the elbow out.

AUTO-DUMP INTAKE FILTER:

The auto-dump filter is located next to the vacuum

intake stand pipe. The filter can be removed by turning

counter-clockwise. Turn Clockwise to re-tighten. Clean

filter after every job.

NOTE: Daily cleaning of the intake filter bag and the

pump intake filter, are essential to preserving the proper

function of the pump out feature. It is up to the operator

to determine a proper cleaning schedule as workloads

differ from job to job. It is advisable to inspect the filters

after the completion of each job to gauge what an appro-

priate cleaning schedule would be.

VACUUM INTAKE FILTER AND VACUUM

SHUT OFF:

The vacuum intake filter houses the float ball which is

in place to shut off airflow to the vacuum motor when

there is too much fluid in the waste tank. This function

keeps the vacuum motor from taking in fluids and get-

ting damaged. Under normal operating conditions, the

mesh screen on the air filter should not get dirty. A dirty

filter is a sign of over-filling. To remove the filter cage,

Pull down on the filter, in a pivoting motion. Clean as

needed. Firmly press it back into place. If there is minor

build up, you may use a towel to wipe off the surface of

the filter.